Running Hardware
Does your Century Coronado handle poorly in tight quarters? We have found a rudder that will help a lot. We've been using it for years. We do have a fairly good stock of the popular rudders, rudder ports, props, shafts (cut to length), shaft flanges, shaft stuffing boxes, flax packing, flange and prop drive keys.

Do you want to put in a bow eye and can't find one long enough? We have 1/2 inch stainless steel bow eyes that are 10 inches long.

General Hardware
We have cotton and nylon pennants for Chris Craft, Century, GarWood, Hacker, Riva and Higgins. We can custom order flags as well.

We can get and have a fairly good stock of new and used hardware - except windshield frames. If we don't have it, we have some phone numbers of folks who may have it. We also buy used hardware, if you have some to sell.

We have a rub rail kit available for 21' and under Chris Craft Runabouts - you know, the 3 sided stuff. Also the rubrail for the spray rails (sold each).

Refinish Supplies
We have a huge inventory of almost all the refinish supplies you need as well as the technical information on doing some of the work. This is available for a fee depending on how many questions you have, how in depth they are, and who you need to speak to. If we have to take the refinish foreman off of production to answer 1/2 hour of questions, we have to charge you for the time. Sorry about that.

    We have:
  • Epifanes varnish & thinner
  • Z-Spar varnish, sealers & paints
  • Interlux paints, filler stains & thinners
  • Pettit racing bronze bottom paint - non anti-fouling
  • Brick-red bilge paint (our own color match)
  • West System epoxy resins
  • Smith & Co penetrating epoxy (like git-rot)
  • Chris Craft Blonde stain (our own mix) 
  • Woodbleach
  • Jasco paint stripper
  • Brushes, buckets, rollers, strainers & sandpaper
  • Masking tapes, long mask tape, fine line tape and 3M masking film
  • Sikaflex, Boatlife, & 3M 5200
  • Pettit paint for waterlines & deck seams
  • Bung plug glue (not Elmers wood glue)

We have counter sinks, bits and plug cutters for sale. There is only one brand we recommend and that is Fuller. They cost more than other brands, but are well worth it. The fit is really good.

We have a huge selection of screws, but not a lot of each size. If you need a large quantity, then we can accommodate you. 5's, 7's, & 9's are NOT available - so you have to go with 6's, 8's, & 10's.

Last Updated ( April 14, 2011 )